Choose a field scenario, then launch it into the panel simulator.
A pull station at the east exit is active. The panel is in alarm and the NACs are sounding.
What the tech sees: ALARM ACTIVE on Z1-04 Pull Station East Exit.
Start in SimulatorA duct detector circuit is in trouble. The goal is to identify the trouble point, view details, and restore it.
What the tech sees: TROUBLE on Z2-02 Duct Detector RTU-1.
Start in SimulatorThe panel has an alarm, a supervisory, and a trouble at the same time. Practice moving through each queue.
What the tech sees: Alarm at lobby smoke, supervisory at waterflow switch, and trouble at duct detector.
Start in SimulatorA tech needs to temporarily disable a server room smoke detector for training, then re-enable it before leaving.
What the tech sees: System normal at start. Use Command Menus and the training PIN if prompted.
Start in SimulatorSeveral trouble events are active. Practice using Next/Previous and acknowledging each event.
What the tech sees: Troubles on Z1-02, Z2-01, and Z2-02.
Start in SimulatorStart walk test, activate a device, then stop walk test before returning the system to service.
What the tech sees: System normal at start. Walk test must be started from the menu or mission shortcut.
Start in SimulatorA notification circuit trouble is simulated as a point trouble. Identify it, acknowledge it, and restore the condition.
What the tech sees: TROUBLE on Z1-03 used as the training NAC trouble source.
Start in SimulatorA ground-fault-style trouble is simulated. Practice treating it as an active trouble and not as an alarm.
What the tech sees: TROUBLE on Z2-01 Server Room Smoke used as the training source.
Start in Simulator